Inverter for Fluorescent Lamps (12V to 120 / 220 VAC )

Jan 132021

Home / Circuits / Power Supply /

12V to 120 / 220 VAC inverter for fluorescent lamps

On many occasions, it is necessary to have a light source in places where we only have 12 volt DC voltage sources. This voltage source can be a common car battery.

If we have fluorescent lamps on hand that normally work on 120/240 volts DC, it would be necessary to have a way to make them work on 12 volts DC. That means we need an inverter for fluorescent lamps.

The circuit shown achieves the goal we need. This inverter is placed between the 12 volt source and the fluorescent tube.

Inverter for Fluorescent lamps operation

Important note: Do not touch the primary winding of the transformer, since in operation, has an alternating voltage of 120/240 Vac.

The inverter circuit is implemented using mainly a 555 timer, configured as an astable multivibrator, a transformer and a bipolar transistor.

In the diagram, it can be seen that the oscillation frequency of the 555 can be modified by changing the capacitor C1 (between 0.001 uF and 0.1 uF) and adjusting the 1 Mega ohm potentiometer.

The oscillation frequency of the 555 is given by: f = 0.72 / (R x C) where R is the value given by the potentiometer.

The high and low time of the 555’s output voltage is the same and is equal to: 0.69 x R x C. The idea is to make the multivibrator deliver a signal of approximately 10 kHz.

555 Timer Pinout

The square signal coming from the 555 make transistor Q into its cutoff and saturation regions through resistor R1 and potentiometer P2.

The collector of the transistor connected to the transformer gives the secondary winding (12 VAC) a square wave.

As a consequence, in the primary winding (the output connected to the fluorescent tube) there is a square wave voltage of 120VAC or 240VAC.

If we adjust the value of the potentiometer, we can vary the intensity of the current that makes the transistor enter its saturation region and therefore makes the intensity of the collector current that passes through the secondary winding of the transformer vary.

The more current in the base of the transistor, the greater the intensity of light in the fluorescent lamp.

Circuit component list

1 555 timer (IC)
1 100 ohm resistor (R1)
1 1M potentiometer (P1)
1 4.7K potentiometer (P2)
1 0.01 uF capacitor (C2)
? capacitors between (between 0.001 uF and 0.1 uF) (C1)
1 TIP41 NPN medium power transistor (Q)
1 12 VAC to 120 / 240VAC transformer (depending on the voltage of the fluorescent tube) (T)
1 40 watts maximum fluorescent lamp