Electronics Area
Tutorials Community Calendar Diagrams Articles Downloads Links
Save Password Forgot your password?
- Active topics (0)
- New Articles (0)
- New Downloads (0)
- Private messages
- My Bookmarks
- Site Statistics
- PM Pager
- Useful links

Members: 39
Active Users:
0 Members and 8 Guests

Top 5 Downloads
Circuit Magic
(Hits: 194)
Symbolic circuits analysis software to simulate AC...
(Hits: 157)
TinyCAD is a program to help you draw circuit diag...
Free PCB
(Hits: 131)
FreePCB is a free, open-source printed circuit boa...
Electronics Assistant
(Hits: 121)
Electronics Assistant is a program that performs e...
VisualSpice Schematic Editor and Mixed Mode Simulation
(Hits: 79)
VisualSpice is a completely integrated 32-bit anal...

How to test Diodes and Bipolar Transistor

How to test Diodes and Bipolar Transistor

How to test a diode

It is very important for an electronic technician to be able to determine if a diode is working well or not since it will allow him to make electronic devices to work properly. However not only technicians need to know that.

For an electronics hobbyist, who is implementing a circuit or checking an electronic project, it is very important to know if there is any problem with the electronic components he is using.

There are digital multimeters (VOM) that test a diode very easily, because it already comes with this option from the factory.

I’ll show you a typical method to check a diode with an analog VOM.

First, the selector must be positioned to measure resistance (ohms), regardless of the scale. We do the following test:

How to test a diode - Electronics Area

1- Join the red lead probe with the anode of the diode (The side that does not have the strip) and the black lead probe with the cathode (the side with the strip).
The VOM will inject a continuous current to the diode

If the VOM shows a low resistance, it means that the diode is forward biased and it is working fine. If this resistance is very high, it may be a sign that it is an open diode and it has to be replaced.

2- Join the red probe lead with the cathode and the black one with the anode.
As in the previous case, we want to have a current flowing through the diode, but now on the opposite direction (from cathode to anode). If the reading shows a very high resistance, then the diode behaves as expected because a it is reverse biased and there is almost not current flow.

If the readings shows a very low resistance this could mean that the diode is in "short" and it has to be replaced.

- The red probe should be connected to the terminal of the same color in the multimeter
- The black probe should be connected to the terminal of the same color in the multimeter (common)

How to test a transistor

How to test a transistor - Electronics Area

The equivalent circuit of the NPN and PNP bipolar transistors are composed of diodes and we follow the same technique we used to test the common diodes.
The testing is performed between the base terminal (B) and the E and C terminals of the transistor. The NPN and PNP transistor have opposite methods.

In the same way as the common diode, if one of these “diodes” (the equivalent transistor “diodes”) does not work as expected, we have to change the transistor.

Note: Although this method is very reliable (99% in all cases), there are some cases where this is not met due to the characteristics of the transistor or diode.
It is suggested to take it as a 100% reliable for practical purposes.

Related links
Zener diode
Schottky diode
Darlington Transistor
Thyristor SCR (Silicon Controled Rectifier)
Benjamin Franklin`s Fluid Theory Amplifiers. Amplification

How to test Diodes and Bipolar Transistor

The Hunger Site

The Rainforest Site

Set as your default homepage Add favorite Privacy   2008-9 ElectronicsArea.com All Rights Reserved MaxWebPortal Snitz Forums Go To Top Of Page