1 Input - 4 Outputs Stereo Audio Splitter

1 Input – 4 Outputs Stereo Audio Splitter

1 Input – 4 Outputs Stereo Audio Splitter

This 1 Input – 4 Outputs Stereo Audio Splitter has a single input and 4 independent outputs, each amplified with an operational amplifier.

Each operational amplifier is configured as an emitter follower, to take advantage of its high input impedance and low output impedance, thus avoiding distortion in sound.

  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
Temperature alarm circuit with Op. Amp.

Temperature alarm circuit with Op. Amp.

Temperature alarm circuit with 741 operational amplifier

This temperature alarm circuit with operational amplifier activates a relay when the temperature of the place to be controlled exceeds a set level. Useful for an oven temperature control or a cooling system

  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
Twilight switch circuit with operational amplifier and LDR

Twilight switch circuit with operational amplifier and LDR

This Twilight switch circuit activates a light, a lamp, a motor, etc., at the time of sunset and performs the reverse process at dawn.

This is an ideal circuit for activating a security light that must be on all night.

  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
Wien-bridge Oscillator with Op Amp

Wien-bridge Oscillator with Op Amp

Wien-bridge Oscillator using Op-Amp The Wien-bridge oscillator, as shown on the basic outline of the diagram below, consists of an Operational Amplifier (OA) in a non-inverting configuration with gain 1+R2/R1 and a RC feedback network with the following transfer function: Where: Combining the first and the second equation we get: The loop gain (BA) is: The Barkhausen criterion […]

  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
Nonlinear Amplitude Control of a Sinusoidal Oscillator

Nonlinear Amplitude Control of a Sinusoidal Oscillator

Nonlinear Amplitude Control of a Sinusoidal Oscillator In any practical oscillator, the loop gain (ßA) must be slightly greater than unity to prevent that the tolerance parameters of components, aging, temperature effects, etc., make that ßA<1 and the circuit not meet one of the oscillation conditions specified in the equation: In which case the circuit will […]

  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •